Description
- Upgraded Design: 10BB 150 watt Solar panels use the latest half-cell technology. Compared with ordinary solar panels, half-cut cell technology can reduce power loss, lower the temperature of solar panels, and reduce the impact of shading on performance.Multiple panels can be connected in series to a 24/48 volt battery
- Sturdy: 12V monocrystalline solar panel can withstand high winds (2400pa) and snow loads (5400pa). The outdoor solar panel is certified ROHS, CE, EL. It can help your device receive the most effective sunlight safely
- Easy Installation: The solar panels 150 watt has a built-in MC-4 connector, which can easily insert and pull out the solar controller. The pre-drilled hole on the back of the panel helps install it in your vehicle, RV or other place you need it
- Built to Last: Corrosion-resistant aluminum frame provides extended outdoor use that ensures the panel can last for decades. Both the IP67 junction box and IP67 MC-4 connectors have excellent waterproof function
- Wide Solar Applications: 150 Watts Solar Panels Monocrystalline Solar Panel High-Efficiency Module PV Power Charger 12V Solar Panels for Homes Camping RV Battery Boat Caravan and Other Off-Grid Applications
Aaron J Bannon –
Compared to pricier, lower technology 5bb 190w solar panels by GoPower being replaced due to an unfortunate incident; performance of these 10bb solar panels falls off much quicker as the solar angle of incidence decreases. When angle of incidence is within 10 degrees perpendicular, performance is comparable and these panels meet their specs, even exceeding them slightly. As for partial shading, the touted improvements of 10bb appear neglible. One 3″ square corner shaded resulted in ~30% current loss with solar angle of incidence of about 80 degrees. Using a Blue Sky Energy SB3000i Solar Boost 30A MPPT Charge Controller with Display.
Dutchie in the Bay Area –
Purchase 2 of the 150 watt solar panels. I ran a test on them for about 4 hours of direct sunlight. And they did very good. I used a 30 amp solar panel controller with 2 12.8v 20ah batteries at 24 volts and a 24 volt 1500 watt rms power inverter. With a volt meter hooked up to the batteries and one point using a 1000 watt Heat gun. I saw a minimum draw on the batteries.
Dutchie in the Bay Area –
Nice panels. The panels come with 4 pre-drilled holes in the bottom for mounting. I added two in front and two in back, since I expect the conditions to be a big more rough.
Seems to produce desired energy.
JR –
X