Description
- [Wide Application]: Daily Output 800wh/day under 4 hours full sunshine condition. Perfect for RV, Caravan, Marine, Camper, Electric scooter, Golf Carts, Power wheels, Trolling motor, Tool trailer, Backup power supply for cabin shed home etc.
- [Excellent Performance]: ECO-WORTHY solar panels use high-performance monocrystalline solar cells, which can provide up to 21.5% higher efficiency sufficient light conditions.
- [Durable]: Corrosion-resistant aluminum alloy frame, so that the panel can be used for decades, and can withstand strong wind (2400Pa) and snow load (5400Pa), with a long service life. Ip65 rated junction box provides complete protection.
- [Complete and Easy]: The back of the pre-drilled and plug-and-play cables allow quick installation, the kit can be connected in series (24V) or parallel (12V) if you need. What you will get: 2 pcs 100W mono solar panel + 2 set of Z mounting brackets + 30A solar controller + 1 pair of 16.4ft 10 awg solar cables + 1 pair of 2-in-1 connectors + 1 pair of 4.92ft tray cable.
- [Warranty]: 1 year with 24/7 tech support, if any problems or questions about the product,please feel free to contact us through Amazon or call ECO-WORHTY hotline for a solution.
jcwoos –
I bought this to keep my motorhome charged. The motorhome is under a roof so I put the panel where it gets about a half day of sunlight and wired it into my solar controller and it is doing a good job of keeping the batteries topped up when I am not using the vehicle. My installed panels are 30 volt, this one is only 20 volts so I actually get less solar production when in open sunlight if I connect it but when the 30 volt panels are inoperative because they are under the roof the solar controller works just fine with the 20 volt input from this panel.
Wayne –
I purchased two of these a year ago, and they have been working fine. I typically get 3.5 to 4.5 amps at ~12v off of each panel on a clear day, depending on the azimuth and elevation in relation to the sun.
► The MC4 connectors are typical and fit nicely into the old connectors.
► They are well constructed. The dual-channel (running around the outside) outer frame is well sealed to the panel itself, and because of its aluminum dual-wall construction, it can easily be drilled for custom mounting needs when the four bolt holes aren’t usable.
I got these to work as replacements for the very old panels I had on our RV roof. I specifically wanted panels that had a little flex to them since an RV roof can flex and twist any panel that’s too rigid or has been mounted solid can and will crack. I’ve had this happen a few times. I now use rubber inserts in the brackets, which mount to the roof so there is a little flex at that point. Plus, if the panel can twist a little, it has a far greater chance of surviving.
Since we keep our RV parked outside even during the winter, they have been exposed to some nasty cold, colder than -40. Since we mounted them using flexible options, they haven’t developed any cracks because of the shrinkage caused by extreme cold. They also don’t seem to have suffered any when in direct sunlight in the summer months as they get extremely hot.
If I need more for a similar application, I will buy again. If I was setting up a solar power system, I would go for a completely different panel. Too long to get into here.
stephane fortin –
I have been replacing all the panels on my off grid property with these.
On a custom south facing frame at a 40 deg angle ( optimal angle calculated for the location ) , 20 of these units along with 4 x 400 watt wind turbines during the non winter months keep my property fully powered ( 5000 AH of power storage, 2 used 12v forklift batteries ). During the winter my 3500 watt backup generator auto-kicks in quite abit but that’s expected during a grey snowy season where its located.
These units stand up much better than their predecessors on the frame, snapped right into place with minimal adjusting of the current mounting brackets.
Recommended !
ed –
Not a cloud in the sky, directly under noon sun with no obstructions, and only pulling 59w. Pretty disappointing. Packaging needs HELP. First one arrived shattered. It’s sent in a fitted box with a very thin sheet of foam for protection. Was pleasantly surprised to see the replacement made it unscathed despite several punctures to the box.
Bill –
Very durable and high quality construction, definitely purchase from this mfg again.
Wayne –
I ordered 3 panels. No fee and one day delivery !!!!! Very good construction.
Ron Gibson –
To help off grid power supply while camping.
Ayla Bennett –
Exactly what we wanted and easy to install
James –
Pour le prix et la performance feu vert. Très bon rendement même sous les nuages. Ces pour ça que c mon deuxième que j’ai brancher avec. L’autre
James –
I tested 2 x 100watt panels in series for my Bluetti AC200Max.
The panels did well production wise to use/charge the battery generators.
I volunteer at festivals and events with Harm Reduction and the panels provide a “glamping” experience at an offgrid event.
An SUV hatch tent, a wooden table that also fit the panels so they are protected and don’t take extra space.
Happy with the purchase and they will mount (removably) to the new shed for offgrid energy.
I’d love to test product…have an electronic engineering technology background and expertise in efficiency. Not for profits are great ways to shine as a company.
messy –
Note: the cables from the solar panels to charge controller and from the controller to the battery cables to the batteries will require appropriate gage connectors and step ups and downs to be attached and made usable. Additionally, the panels come with all brackets to mount on a roof, but if you have a flat roof or desire more optimal tilt, you’ll also need to select an adjustable mount. Connectors and mounts are all available from the Amazon sites!
Hungus –
Everything works, wires are a bit small but can be remedied. If using them in series, this is less of an issue. Will update once I test them under full sun to see what the actual output is.